License plate holder Akron-RS Universal

HIGHSIDER AKRON-RS License Plate Holder

The HIGHSIDER AKRON-RS license plate holder's design perfectly matches the lines of your bike.

The model-specific bracket of the HIGHSIDER AKRON-RS allows mounting to your bike's original attachment points, enabling replacement without further drilling or cutting.
To prevent cable damage, all sharp-edged feed-throughs are protected by a rubber grommet.

The license plate base is made of 2 mm thick sheet steel. It is precisely cut by laser. After bending, it receives a weather-resistant, black powder coating.
This ensures an optimal fit and durability.
The continuously adjustable plate allows you to position it without drilling. An additional set screw secures the plate in this position.

The turn signal brackets of the HIGHSIDER AKRON-RS are width-adjustable, making them suitable for all types of aftermarket turn signals. This adjustability allows you to adapt the turn signal position to various license plate sizes. To enable turn signal mounting without disconnecting the wiring harness, the 8 mm holes are slotted to the side.

You can also individually adjust the reflector's position via a slider. This makes it easy to adapt to different EU license plate designs.

Two rubber washers are included to securely screw on the license plate and reduce vibrations. Another rubber buffer supports the license plate at its bottom edge.

Details:

• model-specific bracket
• continuously adjustable turn signal holders
• slotted turn signal mount for easy installation without cable disconnection
• continuously adjustable reflector, E-marked
• suitable for European license plates
• continuously adjustable tilt angle
• additional screw for optimal position security
• easy fixation without further steps (e.g. drilling)
• easy mounting of the license plate via elongated holes

The scope of delivery of the HIGHSIDER AKRON-RS includes:

• Model-specific bracket with mounting parts
• HIGHSIDER AKRON-RS license plate base
• Adjustable turn signal brackets
• E-marked reflector with adjustable holder
• Mounting instructions

Notes:
• If your original license plate holder has side reflectors, these must be reattached in a suitable position or replaced with new ones.
• Special turn signal brackets are optionally available for the original turn signals.

Tip:
If you haven't found a model-specific license plate holder for your vehicle, HIGHSIDER's universal license plate holders, available in many different designs, are certainly a good alternative.