Akron-RS License Plate Holder (without illumination) - Suzuki GSX-S 1000/GSX-S 1000 F

HIGHSIDER AKRON-RS License Plate Holder

The HIGHSIDER AKRON-RS license plate holder's design seamlessly integrates with your bike's lines.

The model-specific bracket of the HIGHSIDER AKRON-RS allows installation at your bike's original mounting points, enabling replacement without additional drilling or cutting.
To prevent cable damage, all sharp-edged feed-throughs are protected by a rubber grommet.

The license plate is made of 2mm thick sheet steel. Precise cutting is done by laser. After edging, it receives a weather-resistant, black powder coating.
This ensures optimal fit and durability.
The continuously adjustable plate allows you to position it as desired without drilling. An additional security screw keeps the plate in this position.

The turn signal mounts of the HIGHSIDER AKRON-RS are width-adjustable, making them suitable for all types of accessory turn signals. This adjustability allows you to adapt the turn signal position to various license plate sizes. To enable turn signal installation without disconnecting from the wiring harness, the 10mm holes are slotted to the side.

You can also individually adjust the reflector's position using a slider. This makes adaptation to different EU license plate designs no problem.

To securely bolt the license plate and reduce vibrations, two rubber washers are included. Another rubber buffer supports the license plate from below.

Details:

• model-specific bracket
• continuously adjustable turn signal holders
• slotted turn signal mounts for easy installation without cable disconnection
• continuously adjustable reflector, E-approved
• suitable for European license plates
• continuously adjustable tilt angle
• additional screw for optimal position security
• easy fixing without further steps (e.g. drilling)
• easy license plate mounting through elongated holes

The HIGHSIDER AKRON-RS includes:

• Model-specific bracket with mounting parts
• HIGHSIDER AKRON-RS license plate bracket
• Adjustable turn signal holders
• E-approved reflector with adjustable holder
• Installation instructions

Notes:
• If side reflectors are mounted on your original license plate holder, they must be reattached in a suitable position or replaced with new ones.
• The special turn signal holder 280-976 is optionally available for original turn signals.

Tip:
If you haven't found a model-specific license plate holder for your vehicle, the universal HIGHSIDER license plate holders, available in many different designs, are certainly a good alternative.