Akron-RS License Plate Holder (without lighting) - Honda CB650R/CBR650R

HIGHSIDER AKRON-RS License Plate Holder

The HIGHSIDER AKRON-RS license plate holder's design perfectly matches the lines of your bike.

The model-specific bracket of the HIGHSIDER AKRON-RS allows mounting to the original mounting points of your bike, enabling replacement without further drilling or cutting.
To prevent damage to cables, all sharp-edged cable entries are protected by a rubber grommet.

The license plate is made of 2 mm thick sheet steel. It is precisely cut by laser. After bending, it receives a weather-resistant black powder coating.
This ensures optimal fit and durability.
The continuously adjustable plate allows you to position it as desired without drilling. An additional set screw is provided to hold the plate in this position.

The turn signal mounts of the HIGHSIDER AKRON-RS are width-adjustable and thus suitable for all types of accessory turn signals. This adjustability allows you to adapt the position of your turn signals to various license plates. To enable turn signal mounting without disconnecting the wiring harness, the 10 mm holes are slotted to the side.

You can also individually adjust the position of the reflector using a slider. This makes adaptation to different versions of EU license plates no problem.

To securely bolt the license plate and reduce vibrations, two rubber washers are included. Another rubber buffer supports the license plate at its bottom.

Details:

• Model-specific bracket
• Continuously adjustable turn signal holders
• Slotted turn signal receptacle for easy mounting without cable disconnection
• Continuously adjustable reflector, E-approved
• Suitable for European license plates
• Continuously adjustable tilt angle
• Additional screw for optimal position security
• Easy fixation without further work steps (e.g., drilling)
• Easy mounting of the license plate via elongated holes

The HIGHSIDER AKRON-RS includes:

• Model-specific bracket with mounting parts
• HIGHSIDER AKRON-RS license plate holder plate
• Adjustable turn signal holders
• E-approved reflector with adjustable holder
• Assembly instructions

Notes:
• If your original license plate holder has side reflectors, these must be reattached in a suitable position or replaced with new ones.
• The special turn signal holder 280-979 is optionally available for original turn signals.

Tip:
If you have not found a model-specific license plate holder for your vehicle, the universal license plate holders from HIGHSIDER, which are available in many different versions, are certainly a good alternative.