Akron-RS License Plate Holder (without lighting) - Honda CB500F/CBR500R

HIGHSIDER AKRON-RS license plate holder

The HIGHSIDER AKRON-RS license plate holder's design seamlessly integrates with your bike's lines.

The model-specific mounting of the HIGHSIDER AKRON-RS allows for installation at your bike's original attachment points, enabling replacement without further drilling or cutting.
To prevent damage to cables, all sharp-edged openings are protected by a rubber grommet.

The license plate is made of 2 mm thick sheet steel. The precise cut is done by laser. After bending, it receives a weather-resistant black powder coating.
This ensures optimal fit and durability.
The continuously adjustable plate allows you to position it as desired without drilling. An additional security screw keeps the plate in this position.

The turn signal mounts of the HIGHSIDER AKRON-RS are width-adjustable, making them suitable for all types of accessory turn signals. This adjustability allows you to adapt the turn signal position to various license plate sizes. To enable turn signal installation without disconnecting them from the wiring harness, the 10 mm holes are slotted sideways.

You can also individually adjust the reflector's position using a slider. This makes adaptation to different EU license plate designs no problem.

Two rubber washers are included to securely bolt the license plate and reduce vibrations. Another rubber buffer supports the license plate at its bottom.

Details:

• model-specific bracket
• continuously adjustable turn signal holders
• slotted turn signal mount for easy installation without cable disconnection
• continuously adjustable reflector, E-marked
• suitable for European license plates
• continuously adjustable tilt angle
• additional screw for optimal position security
• easy fixing without further steps (e.g. drilling)
• easy license plate mounting through elongated holes

The HIGHSIDER AKRON-RS includes:

• Model-specific bracket with mounting parts
• HIGHSIDER AKRON-RS license plate holder plate
• Adjustable turn signal holders
• E-marked reflector with adjustable holder
• Installation instructions

Notes:
• If your original license plate holder has side reflectors, these must be reattached in a suitable position or replaced with new ones.
• The special turn signal holder 280-979 is optionally available for original turn signals.

Tip:
If you haven't found a model-specific license plate holder for your vehicle, the universal HIGHSIDER license plate holders, available in many different designs, are certainly a good alternative.