Akron-RS License Plate Holder (without illumination)

HIGHSIDER AKRON-RS License Plate Holder

The HIGHSIDER AKRON-RS license plate holder's design seamlessly integrates with the lines of your bike.

The model-specific bracket of the HIGHSIDER AKRON-RS allows mounting to your bike's original mounting points, enabling replacement without further drilling or cutting.
To prevent cable damage, all sharp-edged feed-throughs are protected by a rubber grommet.

The license plate is made of 2 mm thick sheet steel. It is precisely laser cut. After bending, it receives a weather-resistant, black powder coating.
This ensures optimal fit and durability.
The infinitely adjustable plate allows you to position it without drilling. An additional set screw secures the plate in this position.

The turn signal brackets of the HIGHSIDER AKRON-RS are width-adjustable, making them suitable for any type of accessory turn signals. This adjustability allows you to adapt the turn signal position to various license plates. To enable turn signal mounting without disconnecting the wiring harness, the 10 mm holes are slotted to the side.

You can also individually adjust the reflector's position using a slider. This makes adapting to different EU license plate versions no problem.

To securely screw in the license plate and reduce vibrations, two rubber washers are included. Another rubber buffer supports the license plate at its underside.

Details:

• Model-specific bracket
• Infinitely adjustable turn signal holders
• Slotted turn signal mounts for easy installation without cable disconnection
• Infinitely adjustable reflector, E-approved
• Suitable for European license plates
• Infinitely adjustable tilt angle
• Additional screw for optimal position security
• Easy fixation without further work steps (e.g., drilling)
• Easy mounting of the license plate via elongated holes

The HIGHSIDER AKRON-RS scope of delivery includes:

• Model-specific bracket with mounting parts
• HIGHSIDER AKRON-RS license plate bracket
• Adjustable turn signal brackets
• E-approved reflector with adjustable holder
• Installation instructions

Notes:
• If your original license plate holder has side reflectors, these must be reattached in a suitable position or replaced with new ones.
• The special turn signal holder 280-978 is optionally available for original turn signals.

Tips:
If you haven't found a model-specific license plate holder for your vehicle, you're sure to find what you're looking for among the HIGHSIDER universal license plate holders, which are available in many different designs.